Pilih Bahasa Anda
Bahasa Indonesia 
Inggris
Bahasa Indonesia Inggris
Bahasa Indonesia Inggris
1. How to Put Tile (Zig Zag)
Tile Installation must be done in Zig-Zag to reduce
number of stacks overlap in one place, with the goal of getting
piles overlap very precise so as to prevent water from entering
on tile connection (Overlap).
Tile should be installed tightly and blend with battens.
2. Screw Fitting Method
At the time of installation screw on the tile, the installation of the first screw
should start at the center position strap water (red circles) and should
proceed with the installation screw on the mounting position above
The first screw (blue circle), then proceed with the installation
screw the others. Screw position should be parallel to the slope of the roof and
are not allowed to drill from the top.
Screw connection should not be installed close to the tile (overlap)
or water line to prevent water entering through the screw hole.
