When you are cool to relax at home or on a deep break but you are disturbed by the leak from the roof of the house when it rains it really sucks. Especially if there is an event at your home, while when you want to make a complaint to the party who installs but the warranty is over and does not want to come home. You do not get dizzy or angry, it would be better if you try the steps to overcome the problem of leaks on the lightweight steel roof in your home.

Is your house near a tree that is taller than your house? If so, check above the reporter and look for the point where the water appears, it could be a leak that you are experiencing only due to the blockage of the water channel by tree branches or dried leaves. This will result in water entering the house, try to clean it first and see what the results look like when it is cleaned.

If that hasn't worked, or your house isn't near a tree. Try to see during the day and look carefully whether the tile is straight from top to bottom. It could be a human error because the craftsman is not yet proficient in installing lightweight steel tile.

If problems one and two do not exist, you guys should pay close attention to whether there are hollows on your lightweight steel tile, leaks usually occur as a result of a stampede that causes the tiles to become concave and the water turns sideways.

A problem that is not uncommon is the installation of light steel tiles which are irregular. This means that roof tiles that are overwritten are actually piled up and it causes water to enter inside.

The meeting between the tile and the wall is cracked or not cemented to cause water to seep down. Things like this often occur when improper installation and the installer does not care about it.

The slope of your house is not like the SNI standard, it will cause heavy water cannot go down immediately and result in the water sideways meeting the lower plains.

Then what is the solution? When you understand the problem, you can go to a shop that sells lightweight steel roofs to ask for help, usually they can help if the problem is found. If the leak is only due to seepage usually you should buy a special mild steel glue. This will help you to close the incoming water. You can see the results when you have been given special glue for mild steel and see the results. Not difficult right? Therefore, when there is a mild steel roof leak, you should not immediately assume, but first look at where the problem is.

Those are some tips that we can convey, hopefully useful.